Tank Lock [ST605]

A quintessential GIVI product.
The price is high, but I think it's worth it.

My '19 KATANA is a Material Tank with Design priority.:It is plastic, and moreover, the tank shape is also peculiar, and the tank bag of Magnet type and Suction CupType could not be used.

So we introduced this product.
First of all, it is to fix Attachment which is prepared for each car model by using Screw of the oil supply port, but there is nothing especially difficult if it does according to the instruction manual. The use of Screw lock is recommended so that it may not loosen by vibration.

Once the attachment is in place, you just pop the bag on top of the bag and it will push the bag into place under its own weight. I was so worried because it was attached without a second thought, but I drove more than 1000km from the time I bought it to now, including highway, but it never came off.
In addition, the Attachment has a key lock so you can leave the vehicle without worry.

To remove the bag, pull the red plastic lever on the bottom Right Side of the bag backwards. the spring is a little stiff, so it is difficult to remove if you don't pull hard enough. The spring is a little hard, so if you don't pull hard enough, it will be difficult to remove.

The bag can be opened and closed with a double fastener, and the RUNNER 125 fastener has a hole for a key, so you can lock it with a separate lock.

The body is a Hard Type, and I like the fact that it doesn't lose its design characteristics because it doesn't become flattened even if there are few contents.

However, the Fastener is not watertight and the bottom is not coated, so it is better to use the included Rain Cover.

Contrary to the appearance, it is divided into two layers, upper and lower, so it has a lot of storage capacity. The sunglassesTray is attached like an overseas product, but you can also remove it to use more space.

Although the capacity is small, it is equipped with a locking mechanism so you can leave your motorcycle at home when touring. (BF44) The bag is fixed so that it leans toward the front of the tank, so if you pack it too much, it may fall out when you open it.
The OEM Bolt on the feed port Ring is a 3mm hex, but the Bolt you are replacing is a 2.5mm.
There is no lock on the top lid and it is made to be used with a Padlock on the Fastener. This key is not included in the package and must be purchased separately. When opening and closing while riding, it is difficult to operate the Fastener with the Glove on, so I used the Surface Fastener to make it easy to open and close.
Attachment is in direct contact with the body of the tank, but there is a spacer on the refueling port side so that it floats a little. So I put some Vinyl Tape on the back of the legs and cured it. I plan to use it for a while and observe the progress.

I can't use the magnet because my motorcycle has a resin covered tank, so I can't use the magnet. I'm not sure about the Suction Cup formula, so I went with this one. Attachment to the tank side, you can install and remove the bag. It's easy to do. I drove about 50km from the city to a fast flowing main road and it didn't come off during the ride. It was stable.

It can be filled with 500ml plastic bottles and motorcycles. Please refer to the photo with the Gloves (with Protector).

I like the fact that it's molded all over, so it doesn't lose its shape regardless of the amount of luggage it's carrying. It's not for those who want the amount of stuff that goes in, but I would recommend it to anyone who values design and texture.