[Material] Stainless steel [Specifications] Front and rear set [Quantity] 2 units / 1 set
By replacing the DRC brake pin with the DRC brake pin, vehicles from four manufacturers in Japan can be removed and reattached with an 8mm box wrench, greatly improving work efficiency.Lineup for a variety of vehicles. One set can replace the brake pins per vehicle. Made of rust-resistant stainless steel.All in a set of two.
This product is also available as a replacement for the original.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
The brake pin looked like oem quality and fit inside the caliper perfectly. DRC products are really good, a little bit expensive. I prefer hex head instead of allen. Especially when allen tend to take over a bit after a while.Had to drill my oem ones out because they seized in my calipers and the Allen heads stripped out. Got these to replace them. The fitment was great and installation was easy. I've run them for about six rides so far and haven't seen any problems.Overall perfect fit. It looks very solid and high quality. Shipping is very fast, very well packaged. arrived in 1 weekView Detail
I bought it because the OEM came out with Stages. It looks polished and has a high quality feel, and it is stainless steel, so I expect it to be rustproof and durable. The smooth surface may also improve Pad movement.View Detail
When I did the Pad replacement, I saw that the Pin was stepped and worn. The minus on the cap of the pin was so hard that it was about to break, and I had to tighten it loosely, but if I licked it, there would be no next time.
The front brake is a replacement for another vehicle, so I decided to use the one from WR250X, considering the length of the kit.
I changed the tooling from Hexagonal to 8mm Socket and got it installed. Now I'm free from Cap worries.
I'm also worried about electrical corrosion caused by the potential difference between the aluminum caliper and the stainless pin.View Detail
These are the parts that need to be replaced from time to time because of the decrease in the number of steps. The head is 8mm in the hexagon. You can remove it with TWrench, so it's easy to maintain.View Detail
I changed a lot of parts along with the brakeOH The original Pin was textured with rust This will make Maintenance a breeze One thing I was worried about, though, is that I was wondering if I could use Socket wrench, but it was no problem However, I don't know if it is 3/8 because the outer diameter of the Socket is thicker when the angle of insertion is 1/4 It is not View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!